www.SnoBlox-SnoJax.com

WindBar

A year round solution featuring stainless steel for strength and durability, color-match paint and clamp or U-Bracket mounting.
To Place an Order, Please Call (717)697-1999 or 1-800-SNOJAX1

Prices are per L.F. All Bars come in 12 foot lengths: Calculate lineal feet to the nearest 12 foot	Stainless Steel System	Painted Galvanized Bar System	Painted Stainless Steel Bar System
12" to 15" Spacing on Center Seam	$11.00	$12.00	$14.00
16" to 17" Spacing on Center Seam	$9.50	$10.00	$12.00
U-BRACKET MOUNTING	$9.50	$10.00	$12.00
18" to 19" Spacing on Center Seam	$9.00	$9.50	$11.50
20" to 23" Spacing on Center Seam	$8.50	$9.00	$11.00
24" Spacing on Center Seam	$8.00	$8.50	$10.50
SetUp Charge and Paint Matching	None	$50.00 (PER COLOR)
Minimum Order	5 bars (60 LF) Add $50.00 Small-Order Charge if less than 60 LF.	8 bars (96 LF)(PER COLOR) Add $100 Small Order Charge if job is less than 96 LF. (This is in addition to setup and painting charges.)
Finish	Mill (Unfinished) Slight color variations in mill finish of Stainless Steel is not a cause for rejection.	Polane Plus Enamal or Powder Coat For Polane Pluse Enamel, a metal color chip is required to match roof panel color. Color matches are computer matched as close as possible, and any color variations between the bar and panel is not a cause for rejection. Powder Coat is available and color must be selected from our Standard Powder Coat Color Chart.
Delivery	1-2 Weeks after Receipt and Complete Confirmation.	5-6 Weeks after receipt of an approved color chip or selection from the Powder Coat Chart and Complete Confirmation.
System Components (included in L.F Foot Price)	12' Mill Finished S.S. 16 GA. Bar Mill Finished S.S. 12 GA. Clamps per seam 1.25" S.S. Set Screws Plated Tek Screws Plastic End Caps #30(1/8") Drill Bits for pre-drilling Tek Screw holes into the S.S. Bars 3/16 " Allen Bits	12' Factory Painted Galv. 16 GA. Bars Factory Painted S.S. 12 GA. Clamps per seam 1.25" S.S. Set Screws Plated Tek Screws Plastic End Caps #30(1/8") Drill Bits for pre-drilling Tek Screw holes into the S.S. Bars 3/16 " Allen Bits
Wind Stoppers: Recommended over Pedestrian areas. Panels widths 18" or less use one Wind Stopper per panel. Panels greater than 18" use two Wind Stoppers per panel.	$3.00 Each: Aluminum Wind Stopper $4.00 Each: S.S Wind Stopper Includes 1 Tek Screw Each	$4.50 Each: Aluminum Wind Stopper $5.50 Each: Painted S.S. Wind Stopper Includes 1 Tek Screw Each
Flexible Driver (ses to reach Set Screws)	$20.00 Each
5/16" Hex Magnetic Nut Setter	$3.00 Each
PRICES DO NOT INCLUDE FREIGHT OR TAXES. Terms: Check in Advance

Please Read the Warranty Information

To Place an Order, Please Call (717)697-1999 or 1-800-SNOJAX1